Troubleshooting enquiries

Simplex round-off error
I am working this weekend at the office and I am getting an error when I run the OML137 model. Interestingly enough the model runs an...
Wed, 24 Sep, 2014 at 3:57 PM
Solution GOR drops below value specified in material balance
Something I have just noticed with Future which perhaps you could help me explain: I have been checking the forecast output for the wells in my model and...
Wed, 24 Sep, 2014 at 3:57 PM
Lift gas reported for nodes with no total gas
I’ve also got a question about lift gas splits…. Total gas, produced + lift, should be split at the inlet separators and sent to the gas compressors. How...
Wed, 24 Sep, 2014 at 1:19 PM
Discrepency between FUTURE and Excel forecasts
I am trying to get FUTURE to match exactly the attached Excel forecast, but, as you can see from the .ftrx file, the FUTURE profile has some differences,...
Wed, 24 Sep, 2014 at 3:58 PM
Rate and reserves multipliers grayed out in Planned Change
 I'm struggling to apply rate and reserves multipliers within a Planned Change to modify my well potentials.   If I try and do it form the pla...
Wed, 24 Sep, 2014 at 3:59 PM
Are rates averaged over the calculation step period?
One of the major advantages of Future over our old Excel based approach to forecasting is that makes life easier when calculating the MPP (Maximum Produc...
Wed, 24 Sep, 2014 at 2:35 PM
Historical data loaded from Excel is 20-30 times too high
We have been tried to load historical data in Future. However, on checking, the rates were 20-30 times too high.   Could you give me instruction how to l...
Thu, 25 Sep, 2014 at 9:39 AM
Problem with maximum gas-lift rate constraint on well with rate multiplier
Question - On a well with a rates & reserves multiplier, with an Eclipse forecast, the Max Lift gas rate does not work prope...
Thu, 25 Jun, 2015 at 12:34 PM